NPT re-introduces our LC16-8 gasket dispensing machine. Now configured with efficient pattern generation software, setup and productivity have been radically enhanced. Load in gerber photoplot data or DXF information and it now becomes a matter of seconds to select a desired gasket dispense path and even specify automatic lead-in and lead-out path generation. With a standard grid fixture, gasket dispense valve, and 1/10 gallon (300ml) "caulk" tube cartridge holder, this is a complete system. Our LC line comes pre-programmed with several examples that act as tutorials when creating your own production patterns. If you require a system pre-programmed with your production parts or you require additional dispense heads, sensing systems, or axis controls, please consider our CP line of equipment.
This system is compatible with the following materials:
1) Loctite 5910, 5950, 5960 and others - we recommend our CP line with ram pump for 5900 due to high material viscosity.
2) Dymax GA-103 to GA-108 materials.
3) Novagard 400 series moisture cure and 800 series UV/moisture dual cure materials
4) Most materials below 500,000Cps or an extrusion rate of 300g/min or faster.*
For specific materials please call to confirm compatibility.
* Some coatings and facilities may require hooding or duct work to extract any fumes from the workspace. Please take this into consideration when siting equipment.